·Some details are not shown. Please refer to specification sheets for all information.
R5-NE1
Remote I/O R5 Series
ETHERNET INTERFACE MODULE (Modbus/TCP)
MODEL: R5-NE1[1]
ORDERING INFORMATION • Code number: R5-NE1[1] Specify a code from below for [1]. (e.g. R5-NE1/Q) • Specify the specification for option code /Q (e.g. /C01)
[1] OPTIONS blank: none /Q: With options (specify the specification)
SPECIFICATIONS OF OPTION: Q COATING (For the detail, refer to M-System's web site.) /C01: Silicone coating /C02: Polyurethane coating /C03: Rubber coating
RELATED PRODUCTS • PC configurator software (model: R5CON) The IP Address is selectable using the PC Configurator Software. Downloadable at M-System’s web site. A dedicated cable is required to connect the module to the PC. Please refer to the internet software download site or the users manual for the PC configurator for applicable cable types.
GENERAL SPECIFICATIONS Connection Ethernet: RJ-45 modular jack Internal bus: Via the Installation Base (model: R5-BS) Internal power: Via the Installation Base (model: R5-BS) Isolation: Ethernet to internal bus or internal power RUN indicator: Bi-color (green/red) LED; green in normal communications; red when receiving (Function selected with DIP SW) ERR indicator: Bi-color (green/red) LED; the green ON/ blinks in communication errors; red when transmitting (Function selected with DIP SW) Data allocation: Mode 1 or 2 set with the side DIP switch
ETHERNET COMMUNICATION Communication Standard: IEEE 802.3u Transmission: 10BASE-T, 100BASE-TX Baud rate: 10/100 Mbps (Auto Negotiation function) Protocol: Modbus/TCP Data: RTU (Binary) Max. number of socket connections: 2 Transmission media: 10BASE-T (STP, Category 5) 100BASE-TX (STP, Category 5e) Max. length of fieldbus segment: 100 meters IP address: 192.168.0.1 (factory setting); Selectable with PC Configurator Software Port No.: 502 Ethernet indicator LED: LINK, DPLX, LINK10, LINK100, COL
INSTALLATION Operating temperature: -10 to +55°C (14 to 131°F) Operating humidity: 30 to 90 %RH (non-condensing) Atmosphere: No corrosive gas or heavy dust Mounting: Installation Base (model: R5-BS) Weight: 100 g (3.53 oz)
PERFORMANCE Insulation resistance: ≥ 100 MΩ with 500 V DC Dielectric strength: 1500 V AC @ 1 minute (Ethernet to internal bus or internal power)
STANDARDS & APPROVALS EU conformity: EMC Directive EMI EN 61000-6-4 EMS EN 61000-6-2 RoHS Directive EN 50581 Note: Use with Ver.2.00 or higher versions of Power Supply Module (model: R5-PS).
EXTERNAL VIEW
MODBUS FUNCTION CODES & SUPPORTED CODES
MODBUS I/O ASSIGNMENT The DIP SW located at the side of the module switches the unit’s data allocation mode. In the Data Allocation Mode 1, one (1) word is assigned per module. The second channel of analog I/O modules cannot be used. In the Data Allocation Mode 2, two (2) words are assigned per module regardless of whether the second word area is required or not. For discrete I/O, 16-channel area is automatically assigned to each module. With a 4-channel module, the bits assigned to ch. 5 through 16 remain “0.”
I/O DATA DESCRIPTIONS The data allocations for typical I/O modules are shown below. Refer to the manual for each module for detailed data allocations.